SunGlo (700 Series)
Modified Alkyd Enamel

   
DESCRIPTION
  SunGlo is a high quality Modified Alkyd Enamel with excellent coverage, gloss, and durability. It may be applied with or without hardener.
   
COMPONENTS
 
* SunGlo 700............. Color * 142........................... Medium Reducer
* 700C000................. Hardener * 143........................... Slow Reducer
* 141........................... Fast Reducer * 144........................... Very Slow Reducer
   
MIXING RATIO
  Reduce 10-20% with 141-144 Reducer
With Hardener: 8 parts color to 1 part 700C000 Hardener.
   
POT LIFE @ 77 F
  Indefinite without 700C000 hardener
6 Hours with 700C000 hardener
   
CLEAN UP
  Valspar Refinish 100 Thinner (Check local regulations)
   
ADDITIVES
  ACCELERATOR............. N/A
FISHEYE........................... T152 1 oz per gallon.
FLEX ADDITIVE.............. N/A

NOTE: Do not spray when surface temperature is below 50 F.
   
SURFACE PREPARATION

  USE RECOMMENDED UNDERCOAT SYSTEM FOLLOWING RECOMMENDED PROCEDURES.
* Finish sand with P360 grit wet or dry sandpaper or equivalent.
* Mask vehicle thoroughly if panel repairing.
   
SUBSTRATES
 
* AquaPrime 9 * SupaFil 96N/21N * VP Series Epoxy Primers
* SunSeal 82 * SunFil 92 * SupaSeal 97N
* 87N * ColorFil 092 * Properly Prepared OEM Finish
   
APPLICATION
  * Spray two to three medium wet coats allowing 20 minutes between coats.
   
FLASH/DRY TIMES
  AIR DRY @ 77 F
Flash between coats........................... 20 Minutes
Tape Time without Hardener.............. Overnight
Tape Time with Hardener................... Overnight
To Deliver............................................. Next Day

FORCE DRY
Flash before Force Dry...................... 20 Minutes
Force Dry Time................................... 30 Minutes @ 140 F
To Tape................................................ After Cool Down (1 - 2 Hours)
To Topcoat........................................... After Cool Down (1 - 2 Hours)
   
GUN SETUPS
  CONVENTIONAL
Gravity Feed........................ 1.6mm - 1.8mm
Siphon Feed........................ 1.6mm - 1.8mm

HVLP................................... .043" - .052"

AIR PRESSURES
Conventional @ Gun -------- PANEL ----------- OVERALL
Gravity Feed........................ 30 - 35psi .......... 35 - 40psi
Siphon Feed........................ 30 - 45psi .......... 40 - 50psi

HVLP @ Cap....................... 6 - 8psi .............. 8 - 10psi
   
PHYSICAL DATA
    VOC (Unreduced)................ 4.2 - 4.5 lbs/gallon
Volume Solids...................... 34.0-36.0% (Average)
Theoretical Coverage......... 530-584 sq ft per mil per gallon
Flash Point............................ 52 F
   
SAFETY
  Before using any Valspar Refinish product, be sure to read all MSDS and application instructions and warnings. Always wear a properly fitted air purifying respirator with organic vapor cartridges and particulate filter or a fresh air respirator(depending on product selection), eye protection, gloves and protective clothing during application and until vapors are exhausted. Do not permit anyone without protection in the painting area. This product is intended for use by a professionally trained painter.
Keep out of the reach of children.